| Home |
| Search |
| Today's Posts |
|
#1
February 23rd 04, 06:19 AM
|
|||
|
|||
TS130SE Low output
I have a TS130SE which has not been used for a while. I doubt that I
blew the finals when last used, but the output seems to be low. Are there any things like board terminals, relays etc that can cause this effect? I'll try & look deeper, but I wondered if there were any common causes someone might know of. TIA Adrian. |
|
#2
February 26th 04, 04:00 AM
|
|||
|
|||
|
FWIW, I found a wire broken inside its insulation going to a relay.
Fixed. Happy! mustang wrote: I have a TS130SE which has not been used for a while. I doubt that I blew the finals when last used, but the output seems to be low. Are there any things like board terminals, relays etc that can cause this effect? I'll try & look deeper, but I wondered if there were any common causes someone might know of. TIA Adrian. |
|
#3
February 26th 04, 04:00 AM
|
|||
|
|||
|
FWIW, I found a wire broken inside its insulation going to a relay.
Fixed. Happy! mustang wrote: I have a TS130SE which has not been used for a while. I doubt that I blew the finals when last used, but the output seems to be low. Are there any things like board terminals, relays etc that can cause this effect? I'll try & look deeper, but I wondered if there were any common causes someone might know of. TIA Adrian. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Adding an IF output | Equipment | |||
| Adding an IF output | Equipment | |||
| Reflection Coefficient Smoke Clears a Bit | Antenna | |||
| Help with TS-930S Power Output | Equipment | |||
Linear Mode
