Laurie,
Here is one group on yahoo, http://groups.yahoo.com/group/TekSco...guid=145910120
Another is the newsgroup, sci.electronics.repair, this group covers everything under the sun.
I would tell you were to look but the 465 is different than the 466. Mine were on the "interface board"
which is located on the bottom of the scope, they are pins with eyelets in the ends. Voltage should be marked
on the pcb next to the test point pin.
Richard WB8KRN


"Laurie Landry" wrote in message ...
Richard,
I believe that you are on target. I will try to find the TPs and verify
the voltages.
You mention Tek newsgroups. Can you tell me their location.
So far, they have eluded my searches.
Thank you very much for your suggestion.

Laurie