Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
On Mar 30, 10:56?pm, "Not Dloyd" anon@anon wrote:
Not sure how you propose to do that. Will this be a sort of a junction box? There are 10" X 12" plastic access panels for drywall that I can put on the inside, (finished basement). I plan on cutting a 10" x 12" hole in the outer plywood wall and then placing an outdoor utility box with a removable front cover made for electrical over the hole, of course the back of the box wil be opened up to allow access. My shack is in the basement, so I had to deal with getting cables in/out in the least obtrusive manner possible. My poured concrete wall was a hefty impediment. I ended up using a concrete hole-borer to drill a three inch hole through the wall itself, a dusty task to say the least. Yes, I know what you mean. I installed a stove in my basement and had to core drill through the concrete side wall (8" thick), very messy. I then inserted a piece of three inch PVC pipe through the wall and put a 45 degree down angled sleeve on the outside for rain runoff. I can now run my feedlines, 450 Ohm twinlead, and other cables through it. That is where I have my concerns, running ladder line thorough this type of arrangement at legal limit. Yes...there is always the worry about mice finding their way in via the pipe, and I took a page from another Ham who packed his feed-through ABS pipe with soapy Brillo Pads. He said that the steel wool hurts the mice when they chew on it and the embedded soap repels them, and so far, so good. I might mention that my XYL was less than happy about the arrangement, but that goes with the territory. Luckily no concerns with the XYL, she tolerates my hobbies fairly well. As an aside. I 've always read that twin lead should be kept a minimum of two inches from other cables and other metallic objects, such as aluminum siding. In my case, I've found that my twin lead, though packed tightly with at least seven coaxial cables exiting this ABS pipe, works just fine and there are NO adverse effects to any of my rigs. Of course I run but 100 watts, so I cannot, by experience, say that this arrangement would be OK were I to run an amp. Just my experience. Name and call withheld. As I do for obvious reasons. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Routing radio signals around objects | Antenna | |||
PC controlled reciever --- good idea? bad idea? or a just plain ugly one? | Scanner | |||
Schematic and routing programmes | Homebrew | |||
Buried feedline suggestions - Thanks | Antenna | |||
Buried feedline suggestions | Antenna |