Hi Jim and thanks for the reply. It is more than just a numbers thing. The
ICOM website says to use a buffer if you are using a "non-Icom linear". They
don't bother to specify which non-Icom amps need a buffer . Obviously the
specs for each certain ly indicate no need. I have had some hams email me
saying to use a buffer "just in case". I suppose it couldn't hurt.

Good luck on the license upgrades... 73 / DX

--

Charlie
Ham Radio - AD5TH
www.ad5th.com
Live Blues Music
www.492acousticblues.com




"Jim Phelps" wrote in message
...

"Charlie" wrote in message
...
Using an ICOM 746 Pro with an AL-80B amp. According to their respective
manuals the AL-80B sources +12vdc at 100mA and the 746Pro can sink a max
of
+16vdc at 500mA.

QUESTION:
Do I need an amplifier keying buffer according to the above specs? My
research shows primarily these devices are for new rigs keying older
amps.
The Icom site recommends an interface for "all non-Icom amplifiers" but
in
the case of the above specs it appears to me there is already a 4 volt
and a
400mA "buffer" of sorts. The demands of the 80B are well inside the
capabilities of the 746 Pro. Right?

I'm not trying to save $50 or so but if the specs are right I don't need
it.
My rig is new and I have about 300 qsos so far which amount to at least
1000+ successful amp keying events.

--

Charlie
Ham Radio - AD5TH
www.ad5th.com
Live Blues Music
www.492acousticblues.com



You're an Extra and need to ask this? Come on, I've only (previously)
held a Tech Plus and know that 12V is less than 16V and 100ma is less than
500ma! Man, when I go to take my elements I just may go straight to
element 4 - just for fun!