On Jun 2, 1:22Â*pm, Dave Heil wrote:
wrote:
On Jun 1, 1:24�pm, Dave Heil wrote:

Of course someone might protest that the discussion
is about doing the job *chemically*....

Chemically-schmemically. Â*Do they want to remove enamel
or discuss semantics?

Some folks will argue just for the sake of arguing. And while they
will talk a lot about their experience of decades past, they'll not
say much about what they have actually done recently. Particularly in
terms of actually building their own ham rigs or operating on the ham
bands.

All they did
was do straighten out the leads and dip the wire ends
into the pot for about five seconds.

Pretty much standard in the electronics industry, really. Faster and
less costly than Strip-X for production work.

I had the
President of Ideal Tool make a call on Foster with me. Â*His plan
was to
sell one of the company's new abrasive stone type enamel
removing
machines. Â*After the kindly chief engineer showed how Foster
removed/tinned with the solder pot, the man from Ideal told me
that he
didn't believe there was much of a market for his machine.

ooops! Hadn't heard that one before!

At Southgate Radio, for multiple units, an improvised solder pot is
made by heating a cleaned-out tuna can full of solder splashes over a
propane torch or stove burner(with appropriate safety
precautions).
For small jobs, a blob of solder on the 100 watt American
Beauty iron does the job.

Waste not, want not.

That's a key value at Southgate Radio. Also:

Use it up, wear it out
Make it do, or do without

Â*I think I'd just wait until the XYL isn't home and
heat the can on a burner of the gas stove.

That's what I described.

Â*Doesn't it sound like
something which could go terribly, terribly wrong?

Not with "appropriate safety precautions".

Elecraft transceiver kits (except the K3) require that you wind
toroids and strip the wire ends. They recommend the solder-blob
method, and since the wire is relatively small you don't need a big
iron. My military-surplus Weller WCTPK kit does the job very well.

I've often used a razor blade or X-acto knife to get the job done.

Me too, but it depends on whether a tinned wire is wanted.

Now when it comes to terminating a 37 conductor #14 Kerite cable...but
that's another story....

73 de Jim, N2EY