| Home |
| Search |
| Today's Posts |
|
#1
April 13th 09, 02:23 PM
posted to rec.radio.amateur.homebrew
|
|||
|
|||
Need help with GPIB on HP 3586
I have questions like:
* The 3586 manual says in one place that the frequency increase/decrease buttons do not function in the remote mode. In the chart of commands, it says that the GPIB command for increase is UP and the GPIB command for decrease is DN. Does anyone know whether these are valid commands or not? * Can anyone provide a step-by-step procedure for the command sequence to read the 3586 signal magnitude using GPIB? * Which GPIB adaptor do you use? Many thanks. Cheers, John - KD5YI |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FS: GPIB (HPIB) IEEE 488.2 PCI-controller NATIONAL INSTRUMENTS NI. $199 COST FAR BELOW ORIGINAL | Antenna | |||
| Racal RA6790/GM GPIB Codes | Homebrew | |||
| Annc: New release of KE5FX GPIB Toolkit | Homebrew | |||
| [Annc] New V1.6 version of GPIB utilities including HP 7470A plotter emulator available | Homebrew | |||
| GPIB-ENET control software | Homebrew | |||
![John KD5YI[_3_] is offline](https://www.radiobanter.com/images/SultanThemeVB3R/statusicon/user_offline.gif)
Threaded Mode
