| Home |
| Search |
| Today's Posts |
|
#14
August 27th 10, 01:45 AM
posted to rec.radio.amateur.homebrew,sci.electronics.design
|
|||
|
|||
Heating in 4-1/2 turn inductor
On 8/26/2010 7:51 AM, amdx wrote:
"Tim wrote in message ... wrote in message ... I got some confirmation from my collaborator, The 1/2 turn as were describing it was the LAST 1/2 turn wound on the bobbin. It doesn't happen to be nicked, forming a shorted turn perhaps? verified more than once. There isn't a cold solder joint at the heating end of the coil? This would result in localized heating to one end of the coil ... strange is all I can say. Regards, JS |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Drake R8 POP..On turn on | Shortwave | |||
| heating padRFI? | Antenna | |||
| Self-heating of crystal in inverter oscillator | Homebrew | |||
| Drayton Lifestyle LP241 central heating control. | Digital | |||
| Turn $5.00 into 15,000 in 30 days | Shortwave | |||
Threaded Mode
