"raypsi" wrote in message
...
On Nov 4, 11:17 am, JIMMIE wrote:
I came by what appears to be a power supply module from some old
military gear. It uses a synchronous vibrator unless my analysis of
the circuit it way off. My plan is to build a circuit to replace the
vibrator with a couple of power FETs driven by a 555 osc and a bridge
rectfier to handle rectification of the output. I was wondering if
there were any circuit designs around before I started to reinvent the
wheel. Also what freqency do they use. Seems like I heard 100Hz at one
time but I dont trust my memory on something I learned 40 years ago.
Any help would be much appreciate.

Jimmie

A lot of old marine electronics used 60Hz vibrators that worked well
with
transformers designed for 60Hz service. Some of those transformers
actually had primary windings or taps on the primary windings that
matched common 117vac, 60Hz supplies.
Although the cheap, crimped cans (on the vibrators) was ugly to open,
they could be opened and the vibrator repaired. Most had burned or
welded closed points. The points were often good for one or two
filings or dressings before the point of no return. Putting the can back
on was a little messy, but hey, beauty was not usually important.

Old Chief Lynn, W7LTQ