Must have been a real stinker ;@}.

Obviously only conventional R/C stuff is power limited in the way you
describe.

The op stated Ham radio gear,from which I assume SW, and not subject to
the same limitations power wise. However first problems he needs to
solve are probably getting a high enough data rate to know what the
robot is doing. Video is doable, but pretty hard over SW, I don't know
what bandwidths Hams are allowed. Integrating to any micro is simply a
case of converting data into a format that the micro can understand, ie
NRZ serial, or pulse length coded. I would start by looking at something
like the FX929 from CML. it handles the micro to radio interface, and
includes FEC etc, it is designed for short packets. failing that packet
radio, which, as a Ham you should probably knwo more about than I do, is
designed explicitly for data comms like this. You can then choose to
implement your own direct control scheme of the robot, ie PWM motor
controol or what have you, or read up on R/C servos. these are pretty
simple, IIRC 20ms between pulse, and pulse of from 1-2ms to set the
'position' of the servo. Use the micro to convert complex instructions
into servo control signals.

Al

Active8 wrote:

boy, i must have had a bad day.

On Sat, 02 Aug 2003 08:46:28 GMT, onestone
wrote:

Must have been a real stinker ;@}.

Indeed. I must admit to being very curious as to what the application
is, though!
--

"I believe history will be kind to me, since I intend
to write it." - Winston Churchill

On Sat, 02 Aug 2003 08:46:28 GMT, onestone
wrote:

Must have been a real stinker ;@}.

Indeed. I must admit to being very curious as to what the application
is, though!
--

"I believe history will be kind to me, since I intend
to write it." - Winston Churchill