Home |
Search |
Today's Posts |
#18
|
|||
|
|||
Hi All,
thanks for the many responses. My use of this VCO if for a homebrew spectrum analyser, 0-100MHz with a 140MHz first IF. This sort of rules out doing it in ranges - maybe? I'm only an RF beginer, and spicing the circuit gives me "some" confidence that it may work, but I understand that spice may be quite a bit off the mark with parasitics and all. The idea of reducing the RF voltage across the part is a good one, but how do I do it? I am actually using two in series (back to back) but 20 volts peak seems a bit much. I have the ARRL handbook (1997 or so) but this doesn't have much in the way of theory. Is there any other reference anyone can recommend? I could just build it and see if it works, but I wouldn't be able to test much except measure the operating frequency. James. "Tom Bruhns" wrote in message m... Yes, the RF generally does cause nearly instantaneous voltage changes, and therefore capacitance changes, across the diode. Spice should handle this properly. You need to lower that RF voltage! In addition, the average capacitance will depend on the amplitude of the RF because of the nonlinear nature of the capacitance versus voltage, so it's important to keep the RF level reasonably constant, for stability. It's fairly common in covering a wide range, especially if you also want low phase noise, to break it up into subranges which might be selected with switching or PIN diodes. Of course, it's also critical to keep the control voltage "quiet" because at 10MHz/volt or so, a millivolt will give you 10kHz of frequency deviation. If you look up other uses for varactor diodes, you'll find that the characteristic you are asking about is used to make efficient frequency multipliers, and even mixers and amplifiers. (Search for "parametric amplifier.") Cheers, Tom In message , James French wrote: Hello, I have a general question regarding tuning diodes: Does the oscillation voltage alter their capacitance, or is capacitance a slow changing value - like resistance and PIN diodes? The reason I ask is that I am spicing (simulation) a VCO I wish to build (wide range 140-240MHz) and get an oscillation voltage of 20 volts peak (maybe the Q is too high). This high oscillation voltage would easily swamp the tuning voltage, 3-15 volts, and forward bias the diode itself. If anyone wishs to reply directly they must remove the "xxx" from the return address or write to: james dot fenech at nec dot com dot au Thanks, James. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Source for Microwave Diodes? | Homebrew | |||
Source for Microwave Diodes? | Homebrew | |||
Kenwood TS-440S Replacement Diodes? | Equipment | |||
Kenwood TS-440S Replacement Diodes? | Equipment | |||
pin diode attenuators and switches | Homebrew |