Hi all,

I'm just playing around with Eagle Lite this evening and cant seem to
get the thing to connect up components in certain circumstances. I get
a "this bit isn't a member of that bit" type of error message and the
program just refuses me to make the connection. Any ideas?

I believe I saw an error of that sort, if I tried to create a
connection between an individual link, and a multi-signal bus. You
can only do this if the thing you're trying to hook up, has a name
which matches the name of an element of the bus.

Secondly, I see that Autorouter is disabled in the Lite version. Does
that mean that the main benefit of using layout software is denied
me?! I mean, I can spend a few hours making up my own component
footprints in any old drawing program and position them as I wish.
What use is Eagle Lite in that case? Or is there something I haven't
grasped yet?

Hmmm. On the version of Eagle Lite Freeware (Linux) that I have on my
laptop, the autorouter works just fine.

I started with a small battery float-charger schematic I had sitting
around, did a "switch to board", let the program throw the components
down off-board in random locations, dragged the components to the
board and then rotated them to minimize the amount of
signal-connection crossing. I then used "Tools/Auto", approved all of
the defaults, and it routed the whole board in about ten seconds.

You _did_ create both a schematic, and a board layout, as part of the
same design? All of the components fit within the outlines of the
largest board that the Lite version will create?

--
Dave Platt AE6EO
Hosting the Jade Warrior home page: http://www.radagast.org/jade-warrior
I do _not_ wish to receive unsolicited commercial email, and I will
boycott any company which has the gall to send me such ads!

On Tue, 20 Jan 2004 00:51:33 -0000, (Dave Platt)
wrote:


I believe I saw an error of that sort, if I tried to create a
connection between an individual link, and a multi-signal bus. You
can only do this if the thing you're trying to hook up, has a name
which matches the name of an element of the bus.

I can't see the point of this disadvantage.

Hmmm. On the version of Eagle Lite Freeware (Linux) that I have on my
laptop, the autorouter works just fine.

It's disabled on this PC/Windoze version for some reason!

I started with a small battery float-charger schematic I had sitting
around, did a "switch to board", let the program throw the components
down off-board in random locations, dragged the components to the
board and then rotated them to minimize the amount of
signal-connection crossing. I then used "Tools/Auto", approved all of
the defaults, and it routed the whole board in about ten seconds.

The "helpfile" says you can move the components to the board, position
them, click on 'ratsnest' to get "airwires" to appear between the
relevant nodes, then do the tools/auto bit and get the defaults you
specify, then click "go" and the routing is automatically done.
Unfortunately, however, no airwires appear, nor do any tracks. Nothing
happens and the "helpfile" says autorouter isn't a working function in
the Lite version! So far I can't say I'm exactly impressed...

You _did_ create both a schematic, and a board layout, as part of the
same design? All of the components fit within the outlines of the
largest board that the Lite version will create?

Yes.

--

My opinion is worth what you've paid for it.