Thanks Allison.

The Midland is of the second variety you described and will require
retuing the sections once the TX xtal is replaced. Will take further
questions off-line.

73,

C

wrote:
On 4 Jun 2006 21:51:57 -0700, "C" wrote:

Allison,

You might be misunderstanding. I'm modifying a Midland 13-380 to
transmit in the 10 meter band for use as a CW beacon. The xtal is
9.4MHz to replace the transmit xtal per instructions he
http://www.4sqrp.com/resource/10m_beacon/10m_beacon.htm

Seems I do understand but you still didn't answer the question.

OK, that is a CB radio (USA 11M AM flavor). Likely that is a crystal
of the three legged variety wher one leg is a case ground or anchor.

However I have a RS40ch radio in my parts bin where the 10.695mhz
three legged thing is a crystal filter!

Should put the freq up in the 10M beacon portion of the band if I can
hook up the 3 leads correctly and if it is indeed a proper application
for the part.

The question was is it a crystal or a crystal filter? As both come
packaged that way. At 9.4mhz it's likely a crystal. If so the
middle (case ground) is optional.

I don't happen to have the 13-380 schematic but I can make a general
set of comments:

ANY CB radio with a 10.240 mhz crystal and an IC near it has a PLL for
frequency control and conversion 10M is not as simple as just changing
the 10.240 rock. The reasonis the 10.240 is not direcly the TX or RX
"rock" but the reference for the PLL.

CB radios come on three basic flavors. Cheap and old, used a crystal
per channel and were often limited to 3 to 12 channels. OLD 23
channel that used usually combination of 37.x, 10.1xx and 10.5xx
(or 23 and 14mhz) crystals to get RX and TX by mixing the result.
Newer (very late 23ch and ALL 40ch) used PLL system with 10.240 as
reference and PLL chip like 858, 5807, 14506 and maybe a dozen other
part numbers. Those are the most challenging.

Old and cheap crystal per channel just reqires a rock of the correct
type and frequency and some retuning.

Old 23ch required picking a pair of rocks or atlest one to get
the mixed pair to be 10M and then retuning the whole synth and
TX chain. Often changing the rocks from 37.6 and 10.595 (27.005 CB
ch 4) to a 37.6 and 9.56 (for 28.040) means the 10.5mhz osc needs to
be retuned and the tx bandpass filter retuned from 27mhz to 28 before
the unit will transmit at all. If the 37.x osc crystal is changed
that will also have the same effect as then that osc needs retuning
and the band pass filter as well.

The newer PLL based radios are a whole different story and there are
three different topologies for getting the TX frequency. Some are
easier than others. Some will not go without a fight. In any case
schematic for the radio and some understanding of how the PLL
for that radio works is needed to get a result that works. FYI: the
PLL based designs have a TX lockout circuit if the PLL is out of lock
or misprogrammed.

We can discuss off line at kb1gmx at arrl dot net.

Allison