Home |
Search |
Today's Posts |
#2
![]() |
|||
|
|||
![]()
John,
My comments are below your text snippets: I have for the time being disonnected the first mixer, and am able to feed in a 45MHz signal straight into the firts IF amp if I wish. Now if I look at the output of the second IF with a spectrum analyser, with the power off to the first IF, but with the 2nd LO running, I can wind up the second IF's gain, and the noise floor goes up, which I guess is expected, but there are no peaks at 455KHz. This would be expected, as there is nothing to bandlimit the output of the high-gain 455 KHz IF, so you're seeing its broadband input noise amplified by its gain. If I connect the power to the first IF, and then wind the gain of the second IF up, I get a noisy peak at 455KHz, that varies in aplitude with the gain. The input to the first IF has a dummy load. This is also to be expected, as the input noise of the first IF is amplified by its gain, then bandlimited before amplifying in the second IF. The second LO is a crystal oscillator, see my previous questions regarding this. The question is, should I expect to see a peak, I dont think so. What could be causing this? The first IF is in a double sided PCB enclosure. I hope someone can help as this is driving me nuts.... Don't go nuts - it sounds normal. It would be a lot easier to say if everything truly is normal if you could supply some numeric data - fortunately you have a signal generator and a spectrum analyzer. I suggest that you put a signal into the first mixer and observe the output of the last IF on your spectrum analyzer. What input signal level does it take to get 10 dB output signal-to-noise ratio. What level does it take to get the same result feeding a signal into the first IF chain, then the second IF chain, etc ??. Don't worry so much about gain during these tests, just the signal-to-noise ratios. BTW, make sure the analyzer's resolution bandwidth is approximately the same as the receiver's IF bandwidth for these tests, otherwise you'll have to apply a noise bandwidth correction). Good luck Joe W3JDR |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
'Crackling' Noise on HF Band | Shortwave | |||
Icom 746pro Testimonial | Shortwave | |||
signal to noise ratio drops on connecting the antenna | Homebrew | |||
Automatic RF noise cancellation and audio noise measurement | Homebrew | |||
CCIR Coefficients METHOD 6 REC533 // AUCKLAND --> SEATTLE | Shortwave |