N9OGL wrote (without attributes again):
OHHHHHHHHH poor Stevey he won't be able to listen to my information
bulletins on 2 meters booo hooo

I have no use for them, Todd, on 2 meters or otherwise.

Not only are you violating the "no broadcasting" rule of Part 97,
it's now apparent that you have no repsect for established Band Plans.
I cited the exact current plan for the 2 meter plan and this was your
"response".

I think that pretty much sums up what Amateur Radio can expect
from you.

And the reaction you are getting FROM Amateur Radio is pretty much
a result of your lack of respect for the program, Todd.

Steve, K4YZ

I will point out that that is the ARRL National Band Plan....Band plans
do vary from state to state.....but I'm sure your aware of that.

N9OGL wrote (again violating nettiquette by ignoring attributes):
I will point out that that is the ARRL National Band Plan....Band
plans
do vary from state to state.....but I'm sure your aware of that.

OK, Todd...enlighten us with the Illinois 2 meter Band Plan.

Please provide us with the URL to the agency coordinating V/UHF
allocations in Illinois.

Steve, K4YZ

I really know what Illinois Bandplan is.....but I do know it vary from
state to state.....because I believe Califorina does not recognize the
"experimental part" of the 2 meter ham band.

N9OGL wrote (more failure to observe nettiquette noted):
I really know what Illinois Bandplan is.....but I do know it vary
from
state to state.....because I believe Califorina does not recognize
the
"experimental part" of the 2 meter ham band.

Did you mean "I know what the Illinois Bandplan is"..?!?!

Or did you mean "I really don't know what the bandplan is"..?!?!

And you're not IN California, now are you? (Although I quite
readily accept that you're "...in a different state...of mind...")

So...busted AGAIN on yet another bit of INFORMATION that you have
absolutely NO IDEA about but were quite willing to ACT like you did.

Idiot.

Steve, K4YZ

well I do know here in Illinois that they allow voice repeaters on the
Amateur Television frequencies on 440. I also know that here in
Illinois 145.5 to 145.8 is used here in Illinois for everything from
wireless Amateur radio LAN to echolink. if anything I run my
information bulletin on 146.835 Mhz hehehe

N9OGL wrote:
well I do know here in Illinois that they allow voice repeaters on
the
Amateur Television frequencies on 440.

But that's not what we're talking about.

The thread says "N9OGL to bust 2 meter band plan..."

I also know that here in
Illinois 145.5 to 145.8 is used here in Illinois for everything from
wireless Amateur radio LAN to echolink.

So you were ready to knowingly start using a relatively wideband
mode in a part of the spectrum where low power data is being used...

if anything I run my
information bulletin on 146.835 Mhz hehehe

At least you'd be on a repeater OUTPUT, and hence operating on a
frequency planned for simplex and repeater outputs...THEN all you have
to "worry" about will be causing interference to coordinated repeaters
on 146.82 and .85.

So what's your problem with picking an unused simplex frequency
between 146.40-146.595 and 147.405 to 147.585 where simplex is supposed
to be?

Steve, K4YZ