| Home |
| Search |
| Today's Posts |
|
#1
September 26th 10, 05:27 PM
|
|||
|
|||
Newbie Scanner setup question
Hi I have just purchased a base scanner (Commtel COM205) once I got it all set up I was given a Realistic Pro 2042 with aerial, I have also ordered an MRP-2000 MK2 pre-amp, I am a little bit akward as I would like to connect everything up as follows,
2x aerials into coupler then into the pre-amp, split out of the pre amp into the two scanners, I dont know how fussy the scanners and pre-amp are with relation to impedance/ load so I would like to draw on everyones vast knowledge and seek advise. Thanks Steve |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| RS PRO-2054 scanner trunked question....newbie | Scanner | |||
| Scanner Question Newbie | Scanner | |||
| Newbie setup, & need opinions and ?'s about GPvsNGP | CB | |||
| Newbie - Studying for Tech & planning station setup - Vertical antennaquestion | Antenna | |||
| Whcih scanner should I ask Santa for? Newbie question | Scanner | |||
Threaded Mode
