I am looking for the MVT 7000 or 7100. The unit must be in good working condition . Most important: the rotary frequency change knob must operate. I use it t0 design SAW transmitters and it helps to plot the tolerance with RSSI as you swing that Frequency select knob. My unit finally died after 15 years and after buying a 'new' 2184 Radio shack triple trunking Scanner find myself disappointed to say the least. For my work the MVT was better. Please post if you have one! Thanks, MichaelPGS

In article ,
MichaelPGS wrote:

I am looking for the MVT 7000 or 7100. The unit must be in good
working condition . Most important: the rotary frequency change knob
must operate. I use it t0 design SAW transmitters and it helps to plot
the tolerance with RSSI as you swing that Frequency select knob. My
unit finally died after 15 years and after buying a 'new' 2184 Radio
shack triple trunking Scanner find myself disappointed to say the least.
For my work the MVT was better. Please post if you have one! Thanks,
MichaelPGS

If it's of any interest, I have an MVT-7200 sitting on the shelf in the
basement. I don't think the packaging or manual survived the move from my
original apartment, but it has belt clip, soft case (vinyl window is
clouded and yellowish from age) and antenna. I could probably scrounge up
some operating instructions too ... if this would work for you please let
me know and I'll check that it still works.

I tried emailing you but your UseNet gateway does not provide a "real"
emailable address to reply to.

[quote=Mike S.;738957]In article ,
MichaelPGS wrote:

I am looking for the MVT 7000 or 7100. The unit must be in good
working condition . Most important: the rotary frequency change knob
must operate. I use it t0 design SAW transmitters and it helps to plot
the tolerance with RSSI as you swing that Frequency select knob. My
unit finally died after 15 years and after buying a 'new' 2184 Radio
shack triple trunking Scanner find myself disappointed to say the least.
For my work the MVT was better. Please post if you have one! Thanks,
MichaelPGS

Hope this helps - Please let me know details of the unit - price etc. Thanks. Michael

[quote=MichaelPGS;739863]Lets try this - ***michael( you know what to put here) pgselectronics.com

Hi Mike do you still have the dead Yupiteru mvt-7000 or 7100 cause I have the 7000 model which still works but sadly the body is broken and I would like to repair it.
Thanks Charlie B