| Home |
| Search |
| Today's Posts |
|
#1
July 11th 03, 05:38 AM
|
|||
|
|||
PRO-95 scan problem
I have all the freqs in the scanner, with OPEN MODE selected, and the
scanning only stops on a few channels. When I manually go thru the channel list, many channels are indeed active, but in scan mode, it only stops on a few. ATT is on "Normal". I have Radio Shack 800-mhz scanner antenna rubber duckie (just came out) installed. could only "very strong" signals trigger the scan to stop? side note, I installed Maha Energy PowerEx 2200 batteries, and the scanner was turned "ON" on Tuesday at 8 PM and didnt die until Wednesday at like midnite. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| HELP: 2 meter repeater intermod problem from pager transmitters | General | |||
| OT EMI problem with stove and internet connection | Homebrew | |||
| Spectrum Analyser CRT drive problem | Homebrew | |||
| National NCX-5 transmit/receive offset problem | Equipment | |||
Threaded Mode
