| Home |
| Search |
| Today's Posts |
|
|
|
#1
August 7th 05, 01:46 AM
|
|||
|
|||
"Panzer240" wrote in message ... Barry OGrady wrote in : RTFM. Barry ===== Home page http://members.iinet.net.au/~barry.og Very helpful  Mary you can try initalizing the scanner by doing the following: INITIALIZING THE SCANNER If the scanner's display locks up or does not work properly after you connect to power, follow these steps to initialize the scanner. Caution: This procedure clears all information in the scanner's memory. Initialize the scanner only when you are sure the scanner is not working properly. 1. Turn off your scanner by turning VOLUME toward OFF until it clicks. 2. Press and hold 2, 9, and */CLEAR, then turn VOLUME toward MAX to turn on the scanner. Which came of Radio Shacks web site, They don't have the manual there as you said but there is some info about features etc and this was in the installation section  Hoep it helps a bit -- Panzer Thank you!! 'preciate it |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Newbie Questions | General | |||
| Newbie Questions | General | |||
| Newbie | Homebrew | |||
Hybrid Mode
