LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #13   Report Post  
Old March 3rd 06, 02:02 AM posted to rec.radio.scanner
Mr. Man with the Master Plan
 
Posts: n/a
Default Pro 97 volume problems

Just wondering, if you tried to do a re-set of the radio? I doubt that
would do anything, but it might not hurt.

-SMTP


"Allen Crawford" wrote in message
...
I recently purchased a pro97 scanner in near new condition over the
internet
through ebay. The item was
listed as having very low audio such as one has to place the speaker next
to
his ear to hear the broadcast so I took a chance and bought it for 45
dollars. I got it in yesterday and it is totally new! packaging, all
accessories, books and not a scratch on it. Well. I unpack it and install
freshly charged (new) batteries and
I go to playing with it..first..a weather channel..sure enough, very low
volume even when cranked to the fullest
it is still at the same volume level. I went ahead and took out the four
back cover screws and examined the area
where the volume pot is soldered and took some readings. center tap is
about 2.1kohm and 200 k ohm on the non grounded side. (this is without
power
applied)
in the area of the volume/squelch pot, are 3 tiny pots
and 3 test points...(this is all from memory as the scanner
is closed up now). I was hoping for a misplaced speaker magnet or
something
simpler and the circuits are ungodly
miniature and even the audio amp chip is about the size of an op amp on
most
regular size circuits. The doggone thing is so new looking, that it may
be
swapped with a
newer one from radio shack (by swapping backplates) but I don't dare
attempt
the dishonest. Anyway, any suggestions to resolve my dillemma...could it
be
possible that I have a defective volume pot? No amount of regulation seems
to affect the audio at all. The channel
beep come through loud and clear but it seems that either
the preamp from the radio is set too low or the pot is defective/soldered
wrong. Of course, the possibility of
a bad IC has crossed my mind as well. Any suggestions?
No warranty so all I have is either a repairman or my good wits and some
knowledge to help correct the problem. Btw, the sqelch seems to work OK.

Your input would be greally appreciated,

Allen




 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
SSB problems SR Shortwave 3 April 27th 05 02:40 AM
a great read Happy camper CB 1 November 19th 04 02:51 PM
KA-1102 volume fix ??? Michael Shortwave 8 March 29th 04 04:23 AM
Sangean Problems? DeWayne Shortwave 11 March 10th 04 10:36 PM
Bearcat 145XLT problems Tim Scanner 0 February 23rd 04 03:20 AM


All times are GMT +1. The time now is 06:34 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017