Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old January 5th 09, 04:02 AM posted to rec.radio.shortwave
external usenet poster
 
First recorded activity by RadioBanter: Jul 2006
Posts: 4,494
Default Suggested roof antenna for Sony portable

In article ,
Dave wrote:

Telamon wrote:


You'll need a balun to transition from the random wire to the cable.
This will also enable you to put the whole mess at DC ground which will
help protect the radio.


Right, protect it against static electricity.

Make sure the RG6 is properly grounded at the point where it enters
your house.


For RF this is not necessary. If you do ground it outside the house use
a separate ground. Better would be to make one ground radial under the
single wire antenna and ground the coax to a ground rod.

http://www.buxcomm.com/catalog/index...nfo&cPath=8&pr
oducts_id=802


No specifications but probably OK.

Connect the antenna to the red terminal and the ground radial under it
to the black terminal.


You don't understand how brutal lightning is in most places. A Type F
grounding block costs a couple bucks; an 8 foot rod is $8; a clamp is a
couple bucks (I trust he can scrounge-up some #10 copper wire); why skimp?


If lightning is a problem then ground the coax but use a ground separate
from the antenna ground so noise currents from the radio plugged into
the mains has some isolation from the antenna circuit.

If the antenna ground is a wire on the ground under the aerial then the
coax could be attached to a ground rod.

--
Telamon
Ventura, California
  #2   Report Post  
Old January 5th 09, 01:50 PM posted to rec.radio.shortwave
external usenet poster
 
First recorded activity by RadioBanter: Jun 2008
Posts: 1,183
Default Suggested roof antenna for Sony portable

Telamon wrote:
In article ,
Dave wrote:



You don't understand how brutal lightning is in most places. A Type F
grounding block costs a couple bucks; an 8 foot rod is $8; a clamp is a
couple bucks (I trust he can scrounge-up some #10 copper wire); why skimp?


If lightning is a problem then ground the coax but use a ground separate
from the antenna ground so noise currents from the radio plugged into
the mains has some isolation from the antenna circuit.

If the antenna ground is a wire on the ground under the aerial then the
coax could be attached to a ground rod.


The black terminal should connect to the grounded mast. Otherwise,
there are established procedures, as stated in the National Electrical Code.

http://www.dbsinstall.com/DIY/Grounding-2.asp
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
'portable' AM/FM Shortwave Radio Question : Sony ICF-2010 / Sony ICF-SW7600GR / Eton E1 with XM Satellite Radio RHF Shortwave 0 December 3rd 05 09:53 AM
Sony AN-LP1 'portable' Active Loop Shortwave Antenna and an Adapter for the Eton E1 Radio. RHF Shortwave 1 December 1st 05 04:01 PM
FS: Like new Sony ICF-SW100S Mini Portable SW Receiver and Sony AN-LP1 roadwarrior Shortwave 0 March 8th 05 04:52 AM
Get FREE Sony Cameras, Portable DVD Player or Sony Vaio K35 ! ! ! [email protected] CB 0 January 12th 05 12:09 AM
Attn Sony ICF-SW77 Users - Which Indoor Portable Antenna? Dwight Stewart Shortwave 9 May 6th 04 06:29 AM


All times are GMT +1. The time now is 02:02 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017