Home |
Search |
Today's Posts |
#6
![]() |
|||
|
|||
![]()
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1 On 13-03-20 04:31 PM, Joe from Kokomo wrote: Well, if you had two specific radios you were concerned about, try this: 1) Tune both radios to the same station. 2) Put the antenna on rx 1 only and write down the S-meter reading. 3) Put the antenna on rx 2 only and write down the S-meter reading. 4) Connect the antenna to both receivers and see if the S- meter reading is significantly different than in steps 2 and 3 above. Let us know what you find out. Good idea. This may also motivate me to wind that matching transformer I've had plans for. I found a nice fat toroidal core for it in a junked microwave. I will have to look through the past postings to see what the consensus was for the ratio. Nine to one? four and a half to one? mike -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.11 (GNU/Linux) iQEcBAEBAgAGBQJRS0JDAAoJEHacyAc2oGYKKokIAIPFdLuTxU zxYv9nf2Ht3OLA ROlRnbYtp8xA5qR+zAJvCZqJAGzGoxjQUiOfbrE++lWLCLCH7T D52PKCAYZMviWx 7Ut9rZyYu1uT589VrAuM1HX1zQO+YzVIUu3Qot2O/WEuMDAEfYkJzkGiX1iRxrHf +M7xVo5ZTBRAZxrs32yiTxS6X5pa7iEiwvYYmIT+E1vJEHLPwT ktR5ofLnkMzu80 sgQjIeXd/QQ+H6hQP/93xmg3ZQ3+bvNnHl6nlgn1Pfhx5pJllG8FA8ckFmzxXfEL iqbEI+ZCPvU/Z670VAb9IWKo1HnjciH+bxkGuMiA7i94YZJeVpgp+M47OIBuRD w= =dVdr -----END PGP SIGNATURE----- |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Tee-antenna base loading coil? | Antenna | |||
top loading vertical antenna? | Antenna | |||
Linear Loading Loop Antenna | Antenna | |||
Antenna Loading Coils | Antenna | |||
mid loading antenna - problems | Antenna |