Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old November 7th 03, 12:42 PM
RHF
 
Posts: n/a
Default

= = = starman
= = = wrote in message ...
RHF wrote:

KM,

What you say/wrote about electical wiring in the Attic is very true.
- - - Especially if you have any major electrical equipment mounted in
the Attic or on the Roof. Air Conditioners, Fans, ETC.

For Attic Electrical Wiring and Noise
(When the only place you can put an Antenna is in the Attic.)
- - - Think Horizontal Loop Antenna

IMHO: The best type of 'antenna' to use in the Attic is a Horizontal
Loop Antenna. Loops generally have lower/less man made noise pick-up.

* Mount it at least 3-6 Feet above the Attic Floor and follow the
Primeter of the Roof.
NOTE: This has to be a compromise Height vice Size.

* Use a Matching Transformer in the Attic and a Coax FeedLine from the
Attic down to the Radio. (More Noise Reduction.)

iane ~ RHF


What would the typical impedance be for such a (horizontal) loop?
Would it improve reception to make the section of the loop opposite the
feed point go vertically up the attic's gable-end wall to the ridge
peak?



Starman,

Until One Builds It - IT Is An Unknown.
* It is my understanding that this would be a "Receive Only" Antenna.
* The Impedance may range from 100 - 400 Ohms.
* A 1:4 Balun would most likely work will with this In-the-Attic
Antenna.
* Most likely the feed point would be where you cound get the most
direct access for the FeedLine.
* * However, YES - The FeedPoint could be 'located' and the Antenna
Wire 'configured' to improve reception and directivity.
NOTE: Some type of Antenna Tester would be necessary if your were
going to play with the wire to improve the reception and directivity
qualities.

About Roofs:
* Not All Roofs are Peaked - Some are Flat.
* Not All Roof are Squares/Rectangles - Some are "L" Shaped and other.
* * Some Roofs are made of metal :-(


OBTW: As I was writing this and thinking of the possible shapes
within the confines of an Attic; the SpiderWire Antenna came to mind.
= = = http://www.coneantenna.com/Drawings.htm
- - - A form of Double Loop Dipole.
* If you have a Rectangler High Peaked Roof.
* The Feed Point of the Antenna could be mounted at the Center of the
Rectangle and the Peak of the Roof.
* The Four Legs would then be routed down to the bottom corners of the
Roof.
* The Leg ends would then be routed flat with the eaves
* * OR - The Leg Ends could be routed up & down the Attic's gable-end
walls in an Inverted "V".


iane ~ RHF
..
GoTo= http://groups.yahoo.com/group/SWL-AM-FM-Antenna/
..
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Discone antenna plans [email protected] Antenna 13 January 15th 05 12:51 AM
FS: sma-to-bnc custom fit rubber covered antenna adapter Stephen G. Gulyas Equipment 51 December 7th 04 07:42 PM
Yaesu FT-857D questions Joe S. Equipment 6 October 25th 04 10:40 AM
EH Antenna Revisited Walter Maxwell Antenna 47 January 16th 04 05:34 AM
Poor quality low + High TV channels? How much dB in Preamp? lbbs Antenna 16 December 13th 03 04:01 PM


All times are GMT +1. The time now is 05:52 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017