Hello. Excuse me for my bad English. I have a problem with my Love HF150:
the rotating dial make a "noise" (old contact, i suppose...or dust...) and
my problem is open the receiver because the volume knob is very hard to
remove but don't have any screw.
Any idea?
Thank's in advanced.
Dami

"Dami" wrote in message
. es...
Hello. Excuse me for my bad English. I have a problem with my Love HF150:
the rotating dial make a "noise" (old contact, i suppose...or dust...) and
my problem is open the receiver because the volume knob is very hard to
remove but don't have any screw.
Any idea?
Thank's in advanced.
Dami

I have seen nore HF-150 front panels torn up bacuse the person did not
know how to remove the volume knob. Take a sharp knife (Exacto works well)
and pry off the end cap. This reveals the collet tightening shaft). Turn it
CCW and the knob slides off.
Tony at Lowe has replacement encoders.
Dale W4OP

as of a few weeks ago, Tony can not ship any more to north america due to
insurance reasons. I am not sure if that applies to Europe also.


Tony at Lowe has replacement encoders.
Dale W4OP

I doubt Lowe fabricates the encoders. They are built by Alps, are
they not?

On Sat, 6 Mar 2004 19:03:19 -0800, "mike maghakian"
wrote:

as of a few weeks ago, Tony can not ship any more to north america due to
insurance reasons. I am not sure if that applies to Europe also.


Tony at Lowe has replacement encoders.
Dale W4OP