LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #3   Report Post  
Old January 25th 06, 06:12 AM posted to rec.radio.shortwave
junius
 
Posts: n/a
Default Question regarding External Speaker hook-up


Telamon wrote:


I don't understand why you had to "float" the connection from the Drake
SW8 to the Alpha Delta VRC because I don't know what it is. Maybe it was
an active speaker?


Now discontinued VRC, external speaker w/audio filtration (notch, peak,
high freq cut-off, low freq boost/cut-off):
http://www.alphadeltacom.com/pg12.htm

Warning in instruction manual that "if neither radio receiver output
lead is grounded to the radio chassis, e.g. an insulated jack or
balanced output, then DO NOT connect the body of the plug to either
output terminal as this may cause damage to the circuits of the radio
but instead connect the tip of the plug to one of the output terminals
and the body of the plug to the radio receiver chassis. If the radio
otput is an insluated 1/4'' jack as with the Drake SW8, use the
furnished plug adapter and connect the wire lead of the adapter to a
screw on the radio chassis. On other radios with balanced output, make
or buy an adapter to make these connections properly."

As stated by someone previously in this newsgroup: "Be very careful
when connecting Drake radios to active devices like computer speakers
and applifiers. Some sets, the R8 series excluded, have a floating
output, and if one leg is taken to ground by the following device, it
will fry the ouput of the Drake."

So basically, I'm just seeking to make sure that the instruction
manual's caution is not applicable to the following said radios:
'2010, 'SW77, E1


If you are connecting the radio to an external passive speaker you just
have an external isolated voice coil in the speaker and so you just
connect the two wires from the radio using the appropriate plug. Most
speakers are 4 to 8 ohms impedance and most tabletop to large portable
radios have enough power to drive a bookshelf size speaker.


It's not a passive speaker. Sorry, I should have specified.

Headphones
are a better candidate for a small portable.


Yes, I agree by and large; that's why I've never bothered to hook these
up to an external speaker. The filter options on the VRC are pretty
decent, though. Since I've recently taken this speaker out to use with
an R8B, I thought why not give it a go with some other radios.

junius

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
External Speaker for your Radio/Receiver - You Can Hear It ! RHF Shortwave 0 October 27th 05 11:38 PM
FS: Knight Kit R-100 External Matching Speaker Dave Hollander Swap 0 April 4th 04 01:21 AM
Gayboy Stevie Gets His Wish Citizens For A Keyclown-Free Newsgroup CB 19 November 19th 03 12:42 AM
FA: Kenwood SP-831 External Speaker Dave Hollander Boatanchors 0 September 28th 03 02:55 PM
FA: Kenwood SP-831 External Speaker Dave Hollander Boatanchors 0 September 28th 03 02:55 PM


All times are GMT +1. The time now is 06:14 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017