Home |
Search |
Today's Posts |
#1
|
|||
|
|||
QUESTION ON KENWOOD TR-7950
Don't know if this is what u need but I have a Kenwood PL
board. It can be programmed to follow the channel switch or dipswitched. http://tekstuff.freespaces.com/ I dont have any more than the sheet. "Gen. Geroge Hammond" wrote in message ... Hi, thanks for the info. I knew the Piexx unit was available. I have a Com Spec PL unit here and wanted to use it instead of spending the $60. I know the Piexx unit is the exact replacement that allows the radio the 3 PL's. It would be nice but not needed in my situation. THANKS for taking the time for the answer!!!! 73 =================== KC8GXW wrote: Why not put one of these in it. http://tinyurl.com/7wnqo Gen. Geroge Hammond wrote: Hi all, I have a kenwood TR-7950. It does not have the factory PL unit. I want to put a Com Spec board in it. Does anyone know where the deviation pot is on this radio?? I understand I hook up the PL output to the center pin on the deviation control. Also, the "center tuning" LED works on some stations / repeaters but not on all. Is there a pot inside the radio to center this??? 73 |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Kenwood antenna question | Swap | |||
kenwood 520 display question... | Swap | |||
Kenwood THF-6A question??? Drop-in charger?? | Swap | |||
Question Kenwood TS-930S AT | Swap | |||
question on Kenwood TS50 cw QSK????? | Swap |