| Home |
| Search |
| Today's Posts |
|
|
|
#1
August 6th 07, 06:46 PM
posted to rec.radio.amateur.antenna
|
|||
|
|||
cutting end slots in aluminum tubing
hi
I dremel will work nice but you may want to build a small jig to keep things aligned. I would drill a small dia. hole at the bottom of the place where your cut will end so it will prevent the slot from continuing on and splitting the tubing. good luck tom |
|
#2
August 7th 07, 02:03 AM
posted to rec.radio.amateur.antenna
|
|||
|
|||
|
cutting end slots in aluminum tubing
I've used a small table saw with a finish (Trim) cutting blade. Wear
eye protection! |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Aluminum tubing for vertical antenna | Antenna | |||
| Looking for aluminum tubing/rod in DC/MD area | Antenna | |||
| AM Number stations on big-power SW broadcaster slots | Shortwave | |||
| Aluminum tubing? | Antenna | |||
| Cutting your own | General | |||
Hybrid Mode
