"Ralph Mowery" wrote in
m:


"Lostgallifreyan" wrote in message
. ..
Does anyone know what the Sangean ATS-909's external antenna input
impedance
is?

I searched for days for documentation on that radio and found plenty,
mods,
schematics, service manuals, reviews, but no straight word on the
impedance
of that input! (Not even in the service manual specs). The only
reference I
found was a from a guy on a 7-page set of ham reviews, and all he said
was that it was a mystery!

Maybe the only way to know is to start from the schematic but I don't
know how, but here's the best schematic I could find:
http://eric.horsemensociety.info/TEC...chematic_A.gif
(Antenna input is near top right).
(Link appears to be dead, 403, forbidden. I'm sure it worked last
week..)

What I really want to know is whether the ATS-909 will work ok with a
long(ish) wire outside feeding a 50 ohm coax via a 9:1 transformer, or
if that would cause more bother than connecting a wire directly to it
and putting up with local noise picked up from nearby buildings.

Who cares what the impedance is for that radio. Unless you plan on
putting up an antenna for one very narrow band of frequencies, the
impedance of the system will be all over the place. YOu can probably
run coax to the antenna and never have any problems.


Ok, so that's two people saying that could work, and sure, I won't be relying
on a single narrow range, I want to see what's out there and detectable. I
might want to limit peaks and troughs in sensitivity by using a 9:1
transformer though, as I read several times that it is a useful way to do
that for general SW listening via a long wire. That alone means I probably DO
need to care about impedance matching.