Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old February 8th 12, 11:02 PM posted to sci.electronics.repair,rec.radio.amateur.antenna,sci.electronics.design
external usenet poster
 
First recorded activity by RadioBanter: Jul 2006
Posts: 702
Default Increasing Cable TV signal strength


"amdx" wrote in message
...
Hi All,
I'm on a boat, about 170ft from the utility post.
Recently our cable company switched to the wonderful world of
Digital TV. I got the new digital converter and had no picture.
I took the box back and got a second box, still no picture. So now I
suspect a weak signal and confirm that it is the cable length. The cable
company came out and gave me a better cable than I had installed. At this
point I have a picture but it is intermittent. The signal at the utility
post has 3 outputs and had a four way splitter, I suggested the cable guy
put in two 2 way splitters and give me the stronger (first) tap.
That got my signal to work almost all the time. I'd like to get the
signal to work 100% of the time.
I don't has access to electricity at the utility post, so an amp is out.
Although I could try an amp at the cable box end. Is that reasonable?
I would run two cables if there was a way to make it increase signal
strength.
Getting anymore from the cable company is not an option.
Any ideas to get a better signal?
Mikek


At only 170 feet, that should not be a problem. My cable runs down a
utility post, then over 200 feet to my house. It goes to a 2 way spitter
and then about 30 feet to a cable modem. The other end goes to anotehr two
way splitter, one side to a regular TV and the other to a digital box.

No problem with the TV signal at my house, and the internet is around 7 MB
or however they measuer it. That is by my test on the internet and what
they say I am paying for in the speed./


Sounds like they need to send more signal from the main cable to the taps to
your line.


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tecsun PL-310 Signal Strength Metering Richard Fry Shortwave 4 May 17th 10 10:58 PM
What's Your Signal Strength? Chuck Shortwave 4 October 6th 04 10:51 PM
Signal Strength Suggestions Nickolas Antenna 4 August 30th 04 04:53 PM
APRS and signal strength.. Joel Homebrew 0 January 4th 04 11:13 PM
APRS and signal strength.. Joel Homebrew 0 January 4th 04 11:13 PM


All times are GMT +1. The time now is 03:14 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017