Chris;

I have two of the DB224E antennas: In my case, I have the plan to mount the original antenna as-designed, so it will be mounted ABOVE the four-foot side-mounted standoff, and the top-most DB224 will be completely in the clear.

The SECOND DB224 will be mounted UPSIDE-DOWN below the top DB224. The lower DB224 will be mounted on the same stand-off bracket. -Is this CORRECT?? (OK to be mounted upside down?)

QUESTION #1: I need to make a POWER DIVIDER so I can feed both antennas. In tour comments above, I see that you mention that the phasing harness (power divider?) can be made up of 1/4 wave (calculated) lengths of RG-11; If the two legs of the power divider are the same, will this mean that the lower antenna will be fed OUT OF PHASE? (The lower DB224's elements will be "upside down...) -If needed, I could rotate the elements on the lower DB224, so they "hot side" is UP, just like the standard configuration.

QUESTION #2: Is the lower DB-224 to be mounted upside-down, under the top-most DB224? (I am concerned about moisture being trapped in the elements.)

QUESTION #3: What are the possible patterns for the elements? (I now have the top DB-224 set up with two elements facing North, and the other two elements facing South. The LOWER DB224 would be in an omni-directional pattern.)

Thank you!! -Mike- K0JTA