Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
Ron,
I bought a set from Fleeman, Anderson, and BI..... in Florida last year. I found them using Google. Unfortunately I only have the characters of their name that would fit in a Quicken line. They cost ~$17.50 shipped. They sell heavy duty stuff for antennas. Good luck, Ed, N5EI "Ron" wrote in message ... I am going to install a 30' push up mast to the side of my home with 2 brackets but I am not able to locate any house brackets large enough for the 2" and 1 1/2" pipe. Most that I have seen are very flimsy and will only take the normal TV mast. Any ideas on where to purchase the brackets? By the way the mast is going to support a 40 meter dipole and a TGM Hybrid Quad with 1.6 sq. feet of wind load. Ron K3SZY |
#2
![]() |
|||
|
|||
![]()
That would be Fleeman, Anderson & Bird (FAB Corp.)
http://www.fab-corp.com/ Thanks for the tip, I've been looking for these, too. :-) Bill / W5WVO Edward A. Feustel wrote: Ron, I bought a set from Fleeman, Anderson, and BI..... in Florida last year. I found them using Google. Unfortunately I only have the characters of their name that would fit in a Quicken line. They cost ~$17.50 shipped. They sell heavy duty stuff for antennas. Good luck, Ed, N5EI "Ron" wrote in message ... I am going to install a 30' push up mast to the side of my home with 2 brackets but I am not able to locate any house brackets large enough for the 2" and 1 1/2" pipe. Most that I have seen are very flimsy and will only take the normal TV mast. Any ideas on where to purchase the brackets? By the way the mast is going to support a 40 meter dipole and a TGM Hybrid Quad with 1.6 sq. feet of wind load. Ron K3SZY |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Taking apart Hustler mobile mast? | Antenna | |||
Crank up mast homebrew plans?? | Antenna |