| Home |
| Search |
| Today's Posts |
|
#9
January 7th 06, 03:40 AM
posted to rec.radio.amateur.antenna,rec.radio.amateur.misc,sci.electronics.design
|
|||
|
|||
Need some pointers on building UHF/microwave 50 ohm termination/power splitter
On Fri, 06 Jan 2006 22:58:52 +0100, Paul Burridge
k wrote: Hi all, I need a couple of accessories to enable me to make some phase measurements with my HP network analyzer. I'd thought I could pick these up on ebay easily enough, but note the lack of availably with surprise and dismay. I need to therefore contrive two precision parts: Firstly, 50 ohm load that's essentially non-reactive up to 1.3Ghz. Power handling only need be a few tens of miliwatts. N-type connection. http://cgi.ebay.com/HP-909A-50-Ohm-C...QQcmdZViewItem Secondly, a 50 ohm power splitter (one feed-in; three outputs) N-type connections, again flat up to 1.3Ghz. No switching needed, thankfully. I must ask, what is the purpose of this? |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| CATV splitter question | Antenna | |||
| Reducing effects of RF noise? | Shortwave | |||
| CATV splitter question | Antenna | |||
Threaded Mode
