| Home |
| Search |
| Today's Posts |
|
#1
October 26th 19, 02:50 PM
posted to rec.radio.amateur.boatanchors
|
|||
|
|||
how to use the hammarlund hq 145a (tunning)
hi all i was listening to a few stations using my hammarlund hq-145a. i noticed that the band spread dial seems close in terms calibration. The main dial after i set the bandspread to 100 vertical line, stations seems 450 to 550kcs off. I tried to listen to a reference oscillator i can hear it in two places using the main dial. i hear it on both -250kc and +500kc approximately. does this make sense to anybody? regards ferna ve4feb |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| hammarlund hq 145a recap question | Boatanchors | |||
| [QRZ] Eico 145A signal tracer schematic needed | Boatanchors | |||
| Antenna &Tunning SSB | Shortwave | |||
| Hammarlund HQ-145A help needed | Boatanchors | |||
| Busy tunning myself up | CB | |||
Threaded Mode
