Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
In article ,
BFoelsch wrote: The last generation of Tek tube scopes, the 544, 546 and 547 had a solid state vertical section and actually hold up pretty well, but the CRTs are 35 I have a 546 with a 1A1 plugin; bought ca 1980 surplus at Dayton, still works. Only problem is the on-off switch, which has problems with the current draw. I've just replaced it with a calibrated 465, however, so if there's someone in the Bloomington, IN area who wants a scope (with cart) get in touch. I also have an older Ballantine RMS voltmeter which is now not needed (since I now have a newer HP unit). It worked the last time I turned it on, about 15 years ago. Mike Squires -- Mike Squires (mikes at cs.indiana.edu) 317 233 9456 (w) 812 333 6564 (h) mikes at siralan.org 546 N Park Ridge Rd., Bloomington, IN 47408 |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
WANTED: vintage Tekni-Cals water transfer decals | Equipment | |||
Wanted: Old Tektronix Equipment | Boatanchors | |||
Tektronix SUCKS!!!!! | Swap | |||
Vintage CB photo gallery, callsign database and vintage CB recordings now on-line | CB | |||
Wanted: Tektronix Oscilloscopes | Swap |