| Home |
| Search |
| Today's Posts |
|
|
|
#1
March 31st 06, 09:16 PM
posted to rec.radio.amateur.boatanchors
|
|||
|
|||
Drake 2NT with HG10Heath VFO Info needed
I am trying to hook uo a Drake 2NT with a Heath HG10 VFO. I am using an
outboard power supply on the vfo. I am getting hum and chirp on the signal. I have hooked the vfo up both for cathode keying and grid block but same results ie hum/ chirp. Anyone running this same combo? Any suggestions appreciated. Thanks-Lew K1NDV |
|
#2
March 31st 06, 11:13 PM
posted to rec.radio.amateur.boatanchors
|
|||
|
|||
|
Drake 2NT with HG10Heath VFO Info needed
Go to the following location there is the complete directions on tying
the two together. http://www.zerobeat.net/drakelist/2nt-hg10.html 73 Nels W0TUP wrote: I am trying to hook uo a Drake 2NT with a Heath HG10 VFO. I am using an outboard power supply on the vfo. I am getting hum and chirp on the signal. I have hooked the vfo up both for cathode keying and grid block but same results ie hum/ chirp. Anyone running this same combo? Any suggestions appreciated. Thanks-Lew K1NDV |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Drake FS-4 Information Needed | Swap | |||
| FA - R. L. Drake SW8 'portable' World Band Shortwave Communications Receiver | Shortwave | |||
| 60 meter mod info needed... | Equipment | |||
| Gotham Antenna info needed | Antenna | |||
| Vee Beam info needed | Antenna | |||
Hybrid Mode
