| Home |
| Search |
| Today's Posts |
|
#4
October 13th 06, 12:15 PM
posted to rec.radio.amateur.digital.misc
|
|||
|
|||
setting up rigblaster
"wf3h" wrote in message ups.com... OK I can get my blaster to TX or RX but not both. If I set the VOX high it goes to TX. If low it stays on RX. If intermediate it oscillates. Any answers? Could it be RF feedback through the mike cable? That is what happened to me. Ed, N5EI |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Announcing a new Rigblaster discussion group.. | Digital | |||
| Setting up slitting saw for round stock? | Antenna | |||
| SETTING UP AN OPTIMOD AM | Broadcasting | |||
| Rigblaster & USB follow up | Digital | |||
| WTB: RigBlaster with a 4 pin mic connector | Swap | |||
Threaded Mode
