| Home |
| Search |
| Today's Posts |
|
|
|
#1
September 21st 03, 03:00 PM
|
|||
|
|||
TS820S Help w/ display problem ZS6BTP
Hi. My display has gone berserk. When set on known freq.7.000, for example,
the display reads 7117.1. As I move up freq., the .x digit jumps by 2, ie, to 7117.3 On 20 meters, the reading is 15xxx.x throughout the bands. There are other such anomalies. Operations otherwise seems OK. Does Kenwood has a tech support URL? Any thoughts greatly appreciated. Pse respond to Don Bryant |
|
#2
September 23rd 03, 01:20 AM
|
|||
|
|||
|
"
Don, go to the IF board on left side of chassis..on the board top/right corner there is a small trimmer...while watching the readout,adjust the trimmer and when it peaks the readout will fix itself..that is usually the problem with 820 ..GL W4PQW |
|
#3
September 23rd 03, 01:20 AM
|
|||
|
|||
|
"
Don, go to the IF board on left side of chassis..on the board top/right corner there is a small trimmer...while watching the readout,adjust the trimmer and when it peaks the readout will fix itself..that is usually the problem with 820 ..GL W4PQW |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Fluke 27 display problem | Boatanchors | |||
| Heathkit SB-200 Amplifier Problem Help? | Boatanchors | |||
| National NCX-5 transmit/receive offset problem | Equipment | |||
| National NCX-5 transmit/receive offset problem | Equipment | |||
| ft-980 problem... | Equipment | |||
Hybrid Mode
