| Home |
| Search |
| Today's Posts |
|
#6
March 1st 06, 12:23 AM
posted to rec.radio.amateur.equipment
|
|||
|
|||
Kenwood TM-G707A cable
I WAS going to try to diagram my Kenwood PG-4S programming cable/circuit,,,, but after I opened up the 26pin connector, I gave up. The tiny PC board inside had more active components on it than I had realized.... all tiny surface mount. A small 5V regulator IC, possibly another IC (only had 5 pins instead of 8), and 4 or 5 transistors, a diode or two, and a few resistors/caps. Sorry guys, but I don't have the time at present.. Ed |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Kenwood R-5000 (R5000) Receiver - Information and Resources | Shortwave | |||
| Poor quality low + High TV channels? How much dB in Preamp? | Antenna | |||
| Poor quality low + High TV channels? How much dB in Preamp? | Shortwave | |||
| FS: Kenwood Mikes and Transceive Cable for Twins | Equipment | |||
| FS: Kenwood Mikes and Transceive Cable for Twins | Equipment | |||
Threaded Mode
