Home |
Search |
Today's Posts |
#1
|
|||
|
|||
potting - hot melt gule and two part epoxy
Hi All,
Has anyone attempted to use good old fashioned hot melt glue as an encapsulant for modules ? Probably needs melting in a pot over a flame (with appropriate care). A mould could me made out of Plexiglass with appropriate draft (angles) and high temperature release agent. A second thought is to use standard two part fiberglass mix, obviously a lot more rigid, but potting boxes are likely to be needed also. I guess I could use thin walled pipe to house a long rectifier stack and associated capacitors. Both of these options seem significantly less expensive than standard epoxy potting compound... Any thoughts ? Mark |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
The Harry Thomas Special Report - Did The Fires Burn Hot Enough To Melt Structural Steel ? Part 3 of 23 | Shortwave | |||
Holt melt glue as potting agent ? | Antenna | |||
epoxy instead of solder? | Homebrew | |||
potting compound | Homebrew | |||
Potting a balun: wax vs. epoxy vs. urethane foam? | Antenna |