Your injection frequency for the LSB mode probably isn't set correctly. You
didn't say how your audio sounded. If it is lacking low frequency response,
the injection frequency is too far down on the filter slope. This would also
account for the lower output power.
I am not familiar with the innards of this rig..............it is possible
that this could be corrected through a softkey menu. I am sure that this rig
probably has a service menu mode.

Pete

"mongo" wrote in message
...
On 15 May 2004 02:38:03 -0700, (chafik
CN8JV) wrote:

hello my friends
I am using icom 706 MKII
on LSB, I get bad reports about
audio and modulation quality, and the output power is too low.
but on USB the output power is normal with good audio quality
and modulation!
any idea please
thanks 73 CN8JV
AM , FM & RTTY Tx OK?
Tried a CPU reset?
Might be the PLL or main board.
Service manual here;

http://www.acc.umu.se/~nor/.manual/i...ice_Manual.pdf