About Us

December 15th 05, 06:39 AM posted to rec.radio.amateur.homebrew

wrote:
If everything works out this weekend I should have about 10w or so to
drive into a linear. My friend here in town thinks I should buy used
Dentron Clipperton or Heathkit. I don't think 10watts would do either
justice. If 10w would give me a KW out with a commercial unit I would
consider buying a good used unit.

Plan bravo is to build. I would have to do tubes in keeping with the
theme of that side of the shack. CW, AM, & SSB are all modes that I
would operate. I only need to operate 160m - 40m. I am experienced
transistor engineer and my early schooling was in tubes , so not beyond
my reach for this type of a project. I have plenty of other homebrew
projects to keep me busy if this one gets scratched.

I need help picking a topology and a tube set. Price and likelyhood of
getting the thing working are two top runners. From the 1965 ARRL
Handbook I see a few different tubes that might qualify. A Pair of 813
in parallel, 3-400Z, 3-1000Z. I am soliciting some opinions on the
topology. Again, all I got is about 10w am going into. I would like
to do a kw or so pep. I am not looking to buy any parts at this time,
so not looking for any 'sales calls'. I need comments like - look at
this tube with this plate voltage kinda thing. Or try driving this toob
with a such and such to get a kw out. I would like to keep the design
required to a minimum and would consider some 'reverse engineering' a
plus at this point. If I can get most of the design out of an old ARRL
handbook then that would please me.

73
Bob
N9NEO

4CX1000.

Parts *relativly* easy to obtain.
Mechanically strong.
Complete plans in ARRL handbook.
KW+ all day on less than 10W drive.
Wants a bit under 1Amp at 2.5 - 3kV
If possible, get the 'K' model rather than the 'A'. Not so much for the
frequency response as for the more robust screen. If your budget doesn't
stretch to the genuine Eimac, try a copy such as Svetlana's 4CX1600.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to build an amplifier chassis????	Curious George	Homebrew	5	August 12th 05 10:00 AM
VHF Broadband balun 4 to 1 ratio..(50 and 144 mhz)..maybe even up to 440? how to build one?	[email protected]	Antenna	1	March 13th 04 05:09 AM
Ham Radio Deluxe v1.2b, build 308 available	Igor von Uberwald	Equipment	0	February 29th 04 07:33 PM
Ham Radio Deluxe v1.2b, build 308 available	Igor von Uberwald	Equipment	0	February 29th 04 07:33 PM
Want to build PC interface for YAESU 857	Pedro Antonio De Sousa Pedroso	Equipment	0	November 19th 03 03:44 PM

Menu

About Us