Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]() "Dan" wrote in message ... Im getting my shack started and need some input on a good sturdy mobile for 2 meter. Ive looked at several alinco ones and like what I see. Also what does everyone think of the icom v82 ht? Also is a 7 amp power supply enough to run a mobile? I concur with the other's recommendation. I use a Yaesu FT8800 and like the dual band (simultaneous reception and linking) capabilities. I could use a 440 low power ht to key the mobile and transmit at higher power on 2 meters. Because FM requires continuous power, I recommend that you have a power supply capable of 15 amperes ICS if you plan to use it in your shack. If you want to use it to power a 100 watt transceiver as well plus some additional accessories, get a 50 amp supply, but in either case, be certain to evaluate how much rf interference a switching supply puts out. Ed, N5EI |
#2
![]() |
|||
|
|||
![]()
"Edward Feustel" wrote
Because FM requires continuous power, I recommend that you have a power supply capable of 15 amperes ICS if you plan to use it in your shack. If you want to use it to power a 100 watt transceiver as well plus some additional accessories, get a 50 amp supply, but in either case, be certain to evaluate how much rf interference a switching supply puts out. 50 amps is not necessary for a 100w transceiver. (Was that a typo, Ed?) I think the most I've so far ever seen recommended by a radio manufacturer for 100w is 22 amps. For example, my Astron 20A (20 amp - duh) supply powers my IC-735 just fine. I understand what you mean, though, about 2m being continuous, as opposed to CW and SSB being intermittent on transmit. A 20 amp supply would be what I'd recommend for the 2m 50w radio in the shack. Howard N7SO |
#3
![]() |
|||
|
|||
![]() As for power supplies, you should consider a 12-volt Absorbent Glass Mat (AGM) battery with a maintenance charger (the kind that shuts itself off when the battery is fully charged). That will give you pretty much whatever surge current you need, and if your power fails your station stays up. AGM batteries are sealed, can be used indoors, and can be mounted in any position (e.g. on their sides or even upside down, so they claim). They are readily available (I get mine from Batteries Plus). I have a 105-amp-hour AGM battery for my motorhome, and a 33-amp-hour AGM battery for my ARES "go kit". I'm told that the so-called "gel cell" batteries are actually AGM batteries. |
#4
![]() |
|||
|
|||
![]()
On Fri, 18 May 2007 09:42:30 EDT, "Rick (W-A-one-R-K-T)" wrote in :
As for power supplies, you should consider a 12-volt Absorbent Glass Mat (AGM) battery with a maintenance charger (the kind that shuts itself off when the battery is fully charged). That will give you pretty much whatever surge current you need, and if your power fails your station stays up. I strongly agree. These are a great back-up for power failures or for field operations. I work the OKC Marathon every year, running my Yaesu FT-857D and FT-897D from Power Battery Company 91-Ampere-Hour AGM batteries given me when we got rid of our Muckin' Huge UPS at work. When they're not in use, I keep them charged, so that I can run the station during our all-too-frequent power outages. One of them will run a Yaesu FT-*97D for about 8 hours, I've found, in my typical usage pattern, which is listen-mostly. Warning: these are HEAVY! Sulfuric acid and lead both are very dense. The 91AH batteries weigh about 77 pounds each; you want them rigged with some sort of carrying harness if you have to move them, or use a dolly of some sort. If you're putting them on a table, shelf, or other support, it needs to be strong enough, and if they're going in a vehicle or trailer, they need to be secured so that side loads don't cause them to fall. AGM batteries are sealed, can be used indoors, and can be mounted in any position (e.g. on their sides or even upside down, so they claim). They are readily available (I get mine from Batteries Plus). I have a 105-amp-hour AGM battery for my motorhome, and a 33-amp-hour AGM battery for my ARES "go kit". There are lots of sources. Your Yellow Pages will be a great help here. I'm told that the so-called "gel cell" batteries are actually AGM batteries. Seems to be the case. -- Mike Andrews, W5EGO Tired old sysadmin |
#5
![]() |
|||
|
|||
![]()
hi
also check you local hamfests, many SLA batteries from computer data center ups systems recent pulls. Most of the time they are in service 3 years and then pulled and replaced with new. these are under constant float charge and can provide several years of service life for ham radio use. 73 riley |
#6
![]() |
|||
|
|||
![]() "Rick (W-A-one-R-K-T)" wrote in message news ![]() As for power supplies, you should consider a 12-volt Absorbent Glass Mat (AGM) battery with a maintenance charger (the kind that shuts itself off when the battery is fully charged). That will give you pretty much whatever surge current you need, and if your power fails your station stays up. AGM batteries are sealed, can be used indoors, and can be mounted in any position (e.g. on their sides or even upside down, so they claim). They are readily available (I get mine from Batteries Plus). I have a 105-amp-hour AGM battery for my motorhome, and a 33-amp-hour AGM battery for my ARES "go kit". I'm told that the so-called "gel cell" batteries are actually AGM batteries. I'd agree with that. I have a thing here called a "Wizard Power Cube" which I bought at a rally some years ago. It contains a 20AH dryfit lead-acid sealed battery, a maintenance charger and also an input for a solar panel so you can use it when out portable on a contest for example, using the solar panel to get some charge into the battery. I don't recall the make, but I think the guy selling them made them himself. 73 Ivor G6URP. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
how to get the itu recommendations? | Antenna | |||
Need Recommendations for a New HF Amp | Dx | |||
Need Recommendations for a New HF Amp | Equipment | |||
Need Recommendations for a New HF Amp | Dx | |||
Need Recommendations for a New HF Amp | Equipment |