"D. Stussy" wrote in message
...
"homepc" wrote in message
...
I got a GRE P/N: 30-0028 800 MHz rubber angle antenna included when I
ordered my PSR 500 scanner on EBay. The extra antenna was a freebie
thrown
in with the sale. The problem is that it will only screw on halfway.
The
stock OEM antenna fits perfectly. But this folding antenna will only
screw
on halfway just a little shy of the point where the antenna base pins
would
normally drop into place. It doesn't matter if I push down on the
antenna
while screwing it on, it just won't fit.

Is this a common problem or just a one off exception? I was thinking of
selling it, but I don't want to pass on my problem to someone else.

Screw on a BNC? There are NO screw threads on a BNC.


It's not threaded. There are two diagonal guide slots on the antenna collar
that fit over two pins of the antenna base of the scanner. The antenna is
supposed to install by pushing down slightly and giving it a 1/4 turn
clockwise until the antenna base pins settle into a depressed groove at the
end of the diagonal slots.

The angle antenna I got is new but it doesn't have any give when being
pushed down over the antenna base of the scanner.