"Frank346" wrote in message ...
Thanks fred. Anyway to get more frequences out of this thing? possably
more channels?

The article below was found in a modification handbook. I do not own a BC142
and have not tried this mod. Proceed at your own risk.


UNIDEN BC142XL 16 CHANNEL MODIFICATION

The BC-142XL is actually the same scanner as the BC-145XL. It is
basically the same all the way down to the IC controller chip. Both scanners
employ the UC1116 (16 channel Integrated Controller Chip) for this purpose.
However the BC-142XLT is capable of only 10 channels, while the BC-145XL is
capable of 16 channels.

So if both units are basically the same, why the channel difference?
Answer: 1 small 1S1555 diode. This diode is located on the bottom of IC8
(UC1116), the controller chip. It is connected between pin 27 and pin 12
(the cathode connects to pin 27) of IC8. Once this diode has been removed
the unit will now accept and scan 16 channels instead of 10. (Note: This
modification will also work for the BC-140XL scanner.)

Carefully remove the housing screws and disassemble the unit. Remove the
five screws that secure the circuit board to the plastic case. Once this is
done carefully lift the circuit board enough to see the ground wire that
connects the circuit board ground to the metal plate attached to the bottom
of the plastic case and unsolder. Next unsolder the other ground wire that
is connected to the Antenna connector ground. Now the board should lift
out.

Next turn the board over and locate the metal shield cover soldered over
the IC8 board area. Carefully unsolder all five solder connections and lift
the plate off. You should now be able to see the small signal diode
connected between Pin 27 and Pin 12 of IC8. Remove this diode. Once you
have
removed this diode, replace the metal shield and resolder it back to the
circuit board. Reconnect the ground wires and reinstall the circuit board.
If all has gone well you will now be able program and scan 16 channels
instead of 10.

Thanks frank. I programmed emergency paramedics in and its pickin them up now.