what size and type of tool is needed to tighten large tuning knob onto the
shaft. I cant see down the screw hole to see what fixture is at the bottom

Thanks

Yodar

It's a hex head set screw and it's waaaaaay down there!

Frank


Yodar wrote:
what size and type of tool is needed to tighten large tuning knob onto the
shaft. I cant see down the screw hole to see what fixture is at the bottom

Thanks

Yodar

In article .com,
says...
It's a hex head set screw and it's waaaaaay down there!

Frank


Yodar wrote:
what size and type of tool is needed to tighten large tuning knob onto the
shaft. I cant see down the screw hole to see what fixture is at the bottom

Thanks

Yodar



I think it's a 1.5 MM hex, might be 2MM though.

Last R71 I did, that screw was really hard to get out. I twisted up
wrench after wrench. Finally, I got a better quality one, cut off the
shorter side, and put it into my cordless drill and set the torque at 1
and after it shook away for about 20 seconds, it finally let loose, and
it came right out. There was red loctite on the thing! I don't know who
did it, but it sure was a stupid thing to do. I don't know if Icom still
has the knobs in stock. They don't have the PBT and Notch knobs, so
don't lose them!

BDK