LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #15   Report Post  
Old July 1st 09, 09:15 AM posted to rec.radio.shortwave
external usenet poster
 
First recorded activity by RadioBanter: Dec 2008
Posts: 75
Default Tunable active magnetic loop antenna

On Jun 29, 7:25*pm, Telamon
wrote:
In article
,



" wrote:
On Jun 28, 6:17*pm, Telamon
wrote:
In article
,


" wrote:
On Jun 25, 5:29*pm, "Justtis" wrote:
Anyone know of a good site offering build plans. *Prefer plans from
someone
who has built and used same.
I need a quiet antenna like this and Wellbrook is just too
expensive!http://www.wellbrook.uk.com/index.html


I use the ALA100 with home brew loops. Damn good, but you are right
that it is expensive. The ALA100 is the cheapest of the Wellbrook
products. They have some variants of it now. You need a good radio to
use an untuned loop since it delivers a huge amount of RF.


SNIP


So stop whining about the cost and build a low cost passive loop. It if
works well but you still need further improvement it will at least tide
you over.


All the amplification does for you is allow the loop to be smaller,
which may mostly be a convenience depending on the environment.


Be sure to build a balanced loop that only responds to the magnetic
field.


I saw your other post on the subject. Feeding a loop to a 50 ohm input
of a radio will not work well since once side of the loop will be at
ground.


It works very well. I have several loop antennas.

This is where the wideband transformer comes into play. You
can float the loop above ground if you have the transformer. It is
possible to do the same with a differential amp, but *good transformer
would be lower noise.


The transformer is not necessary for a connection to the coax or a
balanced amplifier input.

You could clamp a few ferrite cores around the coax lead-in to the radio
at the antenna connection to block noise coming from the radio if you
don't already have the radio plugged into a EMI noise suppression power
strip.

--
Telamon
Ventura, California


Er, is there a reason you don't want to do this correctly?

The thing with shortwave is you can toss out a piece of wire and get
something. It is all a matter of digging the signal out of the noise.
In any event, the transformers are easily purchased on ebay. Or in
surplus shops if I don't beat you to them.




 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
-FYI- There is a Wellbrook ALA1530 Active Magnetic Loop Antenna currently on eBay RHF Shortwave 0 July 16th 07 05:33 PM
Magnetic loop antenna ( again ) Adrian Scripca YO8SSW Antenna 11 June 22nd 05 06:53 PM
Active magnetic loop antennas Steve Shortwave 2 October 29th 04 01:48 PM
Where to obtain an Ameco TPA tunable pre-amp/active antenna? Joel Kolstad Equipment 0 November 11th 03 05:06 PM
Where to obtain an Ameco TPA tunable pre-amp/active antenna? Joel Kolstad Equipment 0 November 11th 03 05:06 PM


All times are GMT +1. The time now is 02:07 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017