LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #12   Report Post  
Old September 16th 04, 10:32 AM
Mike Terry
 
Posts: n/a
Default

Eric F. Richards wrote in message . ..
(Mark Zenier) wrote:


So anyone with a concern for truth and justice, (and a bit of a flippant
attitude) is hateful?


If his concern was about "truth and justice" AND he'd redirect his
postings to ANY politics group instead of flooding us with them here,
it would be a different story.

In my OPINION (note that I know when to use that word), his worldview
is colored by an unfortunate anti-US bias that a small but vocal
minority in Canada have. Were you here 'round 9/11/01? Remember
psycho-Jim, who was mad on 9/11 for two reasons? 1) not enough
Americans were killed and 2) he couldn't get any music on his radio
that day?

As for his point of view, I might share some of his views. But I
would never, ever consider him an objective observer.


Solar cells have a voltage vs. current curve that's roughly square.

|___ Open Circuit voltage
| ====____. maximum power point

V| \ \
| \ \ "Constant" Current
| \ \
| \ \
|---------------
I ^ available current depends on incident light

The no load voltage is determined by quantum physics and is roughly
constant. The current available is determined by the cell area and
the incident sunlight.

In practical terms, if you don't put the cells in a situation where
they're outputting enough current to damage their internal wiring,
you can hook them up and they'll provide a roughly constant current for
charging a battery. You wouldn't want to use too high a voltage array,
as you could damage the battery.


Bzzzzzt. You were doing fine up to there. Unless you are addressing
alkaline (Ni-Cd) batteries instead of Lead-acid batteries

And if the sunlight goes away, as it
does every day, leakage back through the cell can discharge the battery.


Bzzzzt. Minor problem, not a concern unless you have massively
parallel arrays.

So the simple "chargers" I've seen where switches to disconnect the
battery when its voltage got too high, or there wasn't enough sunlight.


Bzzzt. All chargers are solid-state, PWM based.


If you want to be cost effective, you get a fancy charger that
transforms the load on the solar array to the maximum power point
to get the most bang for the buck.


Back on track again.


Mark Zenier
Washington State resident


Can I put the solar cells in my basement?

Mike Terry.










Obontopic: 14.325 USB hopping, a report of a tornado tearing through
Panama City -- Back Beach Road.

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Amateur Radio Newsline(tm) Report 1420 - October 29, 2004 Radionews Broadcasting 0 October 30th 04 05:28 PM
Solar cell modules maxfoo Homebrew 252 April 30th 04 03:09 AM
Solar cell modules maxfoo Homebrew 0 April 11th 04 03:11 PM
More power questions Jack Twilley General 0 November 14th 03 08:31 PM
Derivation of the Reflection Coefficient? Dr. Slick Antenna 104 September 6th 03 02:27 AM


All times are GMT +1. The time now is 12:52 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017