LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #10   Report Post  
Old October 1st 04, 07:20 AM
m II
 
Posts: n/a
Default

Jack Painter wrote:

Hi Mike,

You are very confused about this, and I will try to correct your
misunderstandings.



Funny, I don't FEEL confused.



=====================================
If you do not use the water pipes as the primary grounding electrode,
because there is no metal water pipe in direct contact with the earth at
least 10’ in length, NEC 250.52.A.1 and if your water pipes are metal,
then you must bond your metal water pipes to the grounding electrode
system. NEC 250.104.A

http://www.homewiringandmore.com/hom...ter/meter.html

or

http://snipurl.com/9gn8

=====================================

Important: The buildings cold water piping is often used to ground the
electrical system in the building.

http://www.e-watertechnologies.com/P...tructions.html


=====================================


http://www.codecheck.com/imagetoo/gecmetal.gif
http://www.codecheck.com/eleccode.htm#anchor1133890

=====================================

While it may be true in our radio world that you can never have enough
grounding for your equipment, The National Electrical Code might not
agree with the philosophy of installing a seperate ground rod at your
home for your radio equipment.

According to the National Electric Code, the telephone service, cable
TV, satellite, and other antenna grounds must be connected to the same
ground point of the incoming electrical service to provide proper
protection. Many times this is not done correctly.

Power surges can enter the house through the electrical, cable TV (or
satellite dish cable), or telephone services. According to the National
Electrical Code, when designing and building a new ham shack, you should
locate the cable TV service and telephone service entrance into the
house near the electrical service entrance. This will help in two ways:

It is very important that each of these systems be grounded to the same
physical ground point as the electrical service. In all cases, the cable
TV and telephone grounds must be physically connected to the ground of
the electrical system. A ground wire must be run from the telephone and
the exterior cable TV boxes to the electric service ground point.


http://www.eham.net/articles/6848?eh...61e080ac23c416

OR:

http://snipurl.com/9gn0
=======================================



Each house also has a good local ground which is connected to input
mains power neutral wire. For example typical small house could use
system such as an 8 ft ground rod or a cold water pipe


http://www.epanorama.net/links/wire_...html#grounding
========================================



mike

--
__ __ __ __ __ __ __ __
/ /\ / /\ / /\ / /\ / /\ / /\ / /\ / /
/ /\ \/ /\ \/ /\ \/ /
/_/ \/_/ \/_/ \/_/ \/_/ \/_/ \/_/ \/_/

..let the cat out to reply..

©Densa International
'Think tanks cleaned cheap'


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Station grounding question: Ken Bessler Equipment 0 October 20th 04 06:00 PM
Outbacker Perth grounding question Bruce W.1 Antenna 0 June 30th 04 04:51 PM
newbie question, grounding joe Antenna 5 May 9th 04 05:55 PM
Antenna mast grounding question Mike Ekholm Antenna 25 December 5th 03 07:26 AM
Grounding question - this is wierd..... John Passaneau Antenna 17 August 31st 03 06:42 AM


All times are GMT +1. The time now is 06:37 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017