| Home |
| Search |
| Today's Posts |
|
#1
March 20th 05, 02:34 PM
|
|||
|
|||
AR-40 controller box problem
Hi Group,
I have a problem with my CDE AR-40 rotor controller box. The controller will drive the rotor into the limit without stopping. I can swap connections 4 and 5 and it goes into the limit in the other direction. I brought the rotor down and checked it on the bench to verify that it was not a cable problem. I also checked it on another rotor with same. Any one help with a schematic or has seen and fixed this problem before? de KJ4UO |
|
#2
March 20th 05, 11:10 PM
|
|||
|
|||
|
Bad limit switch inside the rotor.
" wrote: Hi Group, I have a problem with my CDE AR-40 rotor controller box. The controller will drive the rotor into the limit without stopping. I can swap connections 4 and 5 and it goes into the limit in the other direction. I brought the rotor down and checked it on the bench to verify that it was not a cable problem. I also checked it on another rotor with same. Any one help with a schematic or has seen and fixed this problem before? de KJ4UO |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Yaesu G-450XL Controller box | Antenna | |||
| HELP: 2 meter repeater intermod problem from pager transmitters | General | |||
| OT EMI problem with stove and internet connection | Homebrew | |||
| Schematic jpeg for Yaesu G-5500 Controller needed | Equipment | |||
| Schematic jpeg for Yaesu G-5500 Controller needed | Equipment | |||
Linear Mode
