"John Smith" wrote in message
...
Jim-NN7K wrote:
Hi- was searching Amazon , and see several books on Strip Line Antennas
my biggie is: Eznec will take WIRE DIA, and Dial. Constant, and
Thickness in inches of that dialectric. Does this mean that EZNEC is
useable to substrate material (G-10, Teflon, ect) to model Printed
Circuit antennas?
IF so, how do you go from a WIRE Diameter, to a Rectangular wire,
(say 3 MM X width of 5 MM,by x cm long), on a plane of G-10 ?
Or is this beyond its capabilities? Just curious if can handle this!
Maybe am halucinateing, again!

Comments, please! Jim NN7K

Imagine attempting to model these masks of DLM antennas:

http://assemblywizard.fr33webhost.com/masklayout.pdf

;-)

Regards,
JS

So how would they be fed? Monopole needs a GP or fed as doublet. I have
anxiety just looking at it.

Inverted L is soo much easier.