Home |
Search |
Today's Posts |
#22
![]() |
|||
|
|||
![]()
On Sat, 19 Dec 2009 09:14:46 -0600, Lostgallifreyan
wrote: What I really want to know is whether the ATS-909 will work ok with a long(ish) wire outside feeding a 50 ohm coax via a 9:1 transformer, or if that would cause more bother than connecting a wire directly to it and putting up with local noise picked up from nearby buildings. Hello Dr, Well, I've been on the East Coast for several weeks and am just catching up with your particular problem (which is not too uncommon for SWL'ers who post here). Many suggestions have been useful, but some contra-indicate others, while some merely rely on lore and superstition. One of the last suggestions, from JIMMIE, is probably the single greatest boon for signal strength: Ground. Ground is always the least appreciated component, and is always the single most important one. Ground for RF is not always the same as the ground for safety. Worse yet is that mixing them can sometimes introduce grief (AKA ground loops). ALL grounds should eventually find their way to the service ground. This advice serves both safety and engineering. More can be said - but we move on. One antenna does not always work for all bands (not without a lot of work and the ability to change its polarization). As such, two or more antennas are necessary for SWL'ing. They don't need to be isolated to one band, but if any antenna is resonant for one, it will probably be difficult on another band that is twice or half that frequency. Thus you add another antenna that is half or twice the first's dimension. The benefit here is that they can be wired to the same feed point with little interaction between them. More can be said here too. Matching with a one-size-fits-all doohickey is pabulum for the masses. When it is tossed into the mix, it usually forces the user to add the components already described above that are responsible for most of the benefit attributed to the doohickey. Hosanna's are misplaced. More can be said here, to not good outcome. Matching with an antenna tuner (yes, I am aware of the irony in its name) satisfies all issues (except for the transmission line loss - if it matters) of matching. The tuner's responsibility is to see to it that an unknown source is matched to an unknown load (that is why it has so many adjustments). You can use any Ham grade tuner, get one without a meter to save the big bucks. Whatever product that is designed for the ham bands is satisfactory for the SWL bands. Of course, you could build your own (what a concept!). Matching with a preselector takes the antenna tuner one step further, and protects your receiver from the scourge of these "modern" designs: intermod. The SWL-monkeys who demand the ability to "quickly" tune up different bands/frequencies usually whine and squeel about the difficulty of tuners and preselectors (and in the same breath praise the doohickey's font of blessings). I let them indulge in their illusions and say no more. INTERMOD is the silent killer (as they used to say about high blood pressure). A strong station (a nearby AM transmitter in town) can easily close down your 31M listening experience by simply driving the AGC into overload without you being aware of it. Preselectors and Tuners will drive down that off-band signal, peak the selected frequency, and give you what you tuned for in that band. Beware of imitations that suggest they do the same without tuning (what a crock). As for that antenna impedance. Others have suggested a myriad of possibilities. The first active component's shunt reactance (often the base-emitter capacitance) is the limiting factor even when humongous resistance bridges those same points. Resistance is for bias folks. More can be said, but enough has been said here. Feel free to ask for more to be said. 73's Richard Clark, KB7QHC |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Kaito KA2100 external SW antenna impedance? | Shortwave | |||
Sangean ATS-505 Receiver - Improving your Shortwave Radio Reception with an External Shortwave Listener's (SWL) Antenna | Shortwave | |||
PMR external antenna | Antenna | |||
external antenna.... | Antenna | |||
DX-398 and External Antenna | Shortwave |